Installation Guide

1. Unscrew the existing shower head from the shower hose.
2. Attach the new shower head by screwing it onto the existing hose.
3. Run the water for 30 seconds.

Refill Guide

1. Unscrew the Shower Head from the hose.
2. Open the compartments located in the top cap (back) and the handle.
3. Swap the used cartridges and reassemble.

Installation Guide

1. Unscrew the hose on the water heater. (where the water comes out from the water heater).
2. Attach the shower filter onto the outlet. If the outlet is too close to the wall, use the connector to add more space.
3. Attach the existing hose to the water filter.
4. Run the water for 30 seconds.

Refill Guide

1. Unscrew the Shower Filter from the hose.
2. Open the cartridge compartment by twisting the middle of the shower filter counter-clockwise.
3. Swap the used cartridge and reassemble.